ApexSE/Vector
Pro
- Joined
- Dec 12, 2010
- Messages
- 141
- Reaction score
- 1
- Points
- 76
Kinger, are the double downs a full 2 and 1/2 inches wide (1/2" bar + 1-1/2" spacing +1/2" bar) or 1-1/2" center to center for a total of 2" even?
Thanx
Thanx
kinger
VIP Member
- Joined
- Jan 17, 2005
- Messages
- 7,414
- Reaction score
- 1,553
- Points
- 1,963
- Location
- Clear Lake, IA
- Website
- www.piergenius.com
I'll have to measure again but IIRC it was 2" center to center.
I have over 1000 miles on these and they look new still. Durability is the best I have seen on a carbide. The pushing is there I am still tolerating it, the groups are slowing down a bit so I dont go sliding past the corners. I may swap one side for a single just to see if it helps.
I have over 1000 miles on these and they look new still. Durability is the best I have seen on a carbide. The pushing is there I am still tolerating it, the groups are slowing down a bit so I dont go sliding past the corners. I may swap one side for a single just to see if it helps.
