SIMMER
TY 4 Stroke Master
Hey guys,
Had my RX1 in pieces for the past few months cleaning, changing it over to all black. I haven't started it since early September and even then it fired up with no problems.
I went to fire it today and it wouldn't run without choke and at FULL choke it idled really high (4000 RPM) so I would back the choke off and it would die out. Only after doing this about 5 times and keeping the choke on for about 1 minute was I able to keep it running. Even after it was warmed up and idling on it's own it felt like it was idling rough....any ideas? Could it be as simple as plugs? Fuel Stabilizer is in there with a full tank of fuel AND Fitch Catalysts so i don't think it's the fuel. I am wondering about crap in the carb jets....I hope not what a PITA
I remember back to my 2003 RX1 and all I ever needed was choke on to fire then I would immediately shut the choke off and it ran fine and smooth no matter what the conditions. I can't ever remeber having this problem before.
Any ideas would be much appreciated. I NEVER start the sled unless I let it warm up to operating temperature. It's kind of buggin me because it never did this before. :?
Thanks.
Had my RX1 in pieces for the past few months cleaning, changing it over to all black. I haven't started it since early September and even then it fired up with no problems.
I went to fire it today and it wouldn't run without choke and at FULL choke it idled really high (4000 RPM) so I would back the choke off and it would die out. Only after doing this about 5 times and keeping the choke on for about 1 minute was I able to keep it running. Even after it was warmed up and idling on it's own it felt like it was idling rough....any ideas? Could it be as simple as plugs? Fuel Stabilizer is in there with a full tank of fuel AND Fitch Catalysts so i don't think it's the fuel. I am wondering about crap in the carb jets....I hope not what a PITA

I remember back to my 2003 RX1 and all I ever needed was choke on to fire then I would immediately shut the choke off and it ran fine and smooth no matter what the conditions. I can't ever remeber having this problem before.
Any ideas would be much appreciated. I NEVER start the sled unless I let it warm up to operating temperature. It's kind of buggin me because it never did this before. :?
Thanks.