• We are no longer supporting TapaTalk as a mobile app for our sites. The TapaTalk App has many issues with speed on our server as well as security holes that leave us vulnerable to attacks and spammers.

Yamaha Attak only runs when cranking, fuel pump power turns off in run key position

benmcmahon22

Newbie
Joined
Feb 27, 2022
Messages
1
Age
40
Location
Nottingham NH
Country
USA
Snowmobile
2006 Yamaha Attak
2006 Yamaha Attak

Odd electrical issue, hoping someone has insight.

Diagnosis:

1) Fuel pump has power at the pump when cranking ONLY, and engine runs only while cranking. When key is released into run position, power to fuel pump turns off. Ignition remains on at dash, lights etc.

2) Consistent with (1), I do not get the fuel pump prime when ignition is switch from off to run (as is typical before you start cranking).

3) Fuel pump relay is good (obviously due to (1)), ignition switch is good (checked for signals at ECU). Signal coming out of ECU to fuel pump relay behaves as described in (1), i.e. no power to fuel pump relay in run position, but power applied when cranking.



Is there any sensor that would be causing the ECU to cut power as described? No codes are shown on the dash.
 

x3 bad ign switch.
 
Any chance you swapped the starter relay and this started to happen?
 


Back
Top