Search results

I saw those VK ski skins on the dealer floor a few weeks ago...SUPER wide

Had it set up with the perfect amount of "outside" ski lift that day....lol

I know just had to vent my DOUBLE frustration...lol

Between the 6 day forcast below and a blown engine, my season is DONE Long Term Forecast Updated: Saturday, March 10, 2012, 15:00 CST High 7°C 9°C 14°C 11°C 18°C 18°C Low 0°C -1°C -3°C 2°C 2°C 5°C

yes use a grease injector needle, or replace all wheels with wheels with replaceable bearings http://www.grainger.com/Grainger/WESTWA ... edle-1ZTC7 Should be able to find one at most hardware, fastener, bearing stores etc.

I have done this for over well 30,000 kms on my yamahas with great results (no bearing failures). I do it twice a season.

I liked the yamaha mtn ski with some decent carbides on the trail, and off trail they were fine for what we do...WAY better (and safer) then the stock skies in the ditch and off trail

It sure does... just hoping my experience can save someone else's powerplant.

This is a FYI, not a rant: My 06 Nytro was side swiped from the rear, on the trail a week or so ago. Light damage including running board and some side plastic damage. What I did not notice was the kinked oil hose coming from the bottom of the oil tank. Seems the collision moved the oil...

clean the carbs very well

here is the location: http://www.totallyamaha.com/snowmobiles ... el_kit.htm

zero

Same here, great service and results also

heelingcowboy1 Great seller. Very good packaging, good pricing, all as described, great communication.

you could look in the classifieds for a apex, attak, or rs nytro seat. see link: http://www.ty4stroke.com/viewtopic.php? ... =apex+seat

I have the same problem, my stock cover does not fit well with my riser. So it is not just how you put it on.

if you find any wear, I would suggest only using OEM busings, pins etc.. i have tried generic ones in the past and found them to not fit properly, and wear very fast.

i guess there is no need to remove it, I just do on my 06 nytro because I put the battery up on my shelf, as I pull the airbox anyway to drain and clean my carbs

also remove drive belt, loosen track, removal of battery with a tender on it

would be nice if yamaha put a greasable bearing with a zerk in that location