Primary Clutch Roller issue

[Thunder Products]

Thanks for all the replies. I'm checking on warranty but ordering the Thunder rollers. If the dealer can warranty then I'll have spares.

Hi Ronzx9....Thank you for your order, they are packaged and on their way!

 

[ronzx9]

Awesome and thank you!

 

[Carla 123]

http://www.thunderproductsclutching.com/

This is where I got my rollers.

Yup.these guys are great

 

[STAIN]

Primary roller bushing issue? Never heard about it!
View attachment 143686


What i used to instal and remove bushing. One way for roller the other for weight
View attachment 143685
View attachment 143684

how are those bronze bushings working???

 

[Tuesdayx]

Primary roller bushing issue? Never heard about it!
View attachment 143686


What i used to instal and remove bushing. One way for roller the other for weight
View attachment 143685
View attachment 143684

Did you make that press set up?

 

[Byam]

how are those bronze bushings working???

Not enough WOT testing to talk.... but i think they will solve the problems

i have the thunder 14,8 in my clutches for now

Did you make that press set up?

The little "push pin"tool i have is made by GForce

 

[yamahahaapex]

I was told that clutch components are only covered for the first year. Got into it with my dealer last year because they "updated" my secondary rollers at one point but apparently those were the same as the original ones. They never informed me that a different one came out. Last winter when they flat spotted again I found out there was a different roller that I did not have but he claimed it was too late for Yamaha to cover them even though the problem started and was known within the first year.

We get 3 mos in Canada. The way its going with snow by the time my 4 year warranty is up ill be lucky to have 3,000miles

 

[**sj**]

I hear yamaha considers rollers wearables and wont cover past year one..

 

[swrtxlr]

Primary roller bushing issue? Never heard about it!
View attachment 143686


What i used to instal and remove bushing. One way for roller the other for weight
View attachment 143685
View attachment 143684

How much clearance are you leaving between the pin and bushing?

 

[Byam]

How much clearance are you leaving between the pin and bushing?

I don't have a 1000$$ tool to be extremely precise.

Normaly they are all betwen 0.005/0.007
I have try different material and different pressfit, they all "slip" clockwise inside the roller. When it does that, couple of miles and they are totally shot:-/