Drive shaft ring groove gone

[cannondale27]

I have never needed a strap to get clip on. Some do. Some dont.

 

[grizztracks]

I would shim so that the rotor has very slight movement. I also made the insert out of steel and sized it for a loose press fit. The step allows it to be tac welded inside the drive shaft. If I remember right I did 3 tacs to hold the insert in place and it ran on the hybrid Viper all last season without any problems.

 

[Janne339]

Remember the Old Yamaha Forward clutches like on Phazer? Still thats under spring pressure. For the disc to take out snapring like that the Caliper must be pushing on it more on the inside pad. Look carefully at Caliper. Bet you find grooves. Mine was covered under warranty.

None of that accounts for the magnets hitting cover of chaincase. Wow just Wow. They measured wrong.

As you say, my Caliper showing ugly grooves from the outside pad! Gonna post pics later.

 

[WVTurboLTX]

Left just a little wiggle room. Should be good now.

 

[Allan]

Left just a little wiggle room. Should be good now.

Great looking job

 

[cannondale27]

Beautiful!

 

[grizztracks]

Done Once......Done Right!

 

[Rich Kay]

This stuff just should not be happing with the mountain engineering knowledge from everything that has ever been built!

 

[jaydaniels]

Don't worry... The stress is on the chaincase cover...

Maybe a shims behind the bearing in chaincase?

View attachment 133621

Yikes. That’s doesn’t look good.