Once upon a time, I had a belt blower, then Mike Knapp and Clutchmaster did some magic

[ROCKERDAN]

Brent did you try the Ultimax already?

 

[PowderFalcon]

Not slipping.....too much backpressure is making heat IMO

Mine did same.
Dan

Ran 6,2 yesterday. Still hot

 

[PowderFalcon]

Brent did you try the Ultimax already?

Yup grenaded that belt in 300 miles

 

[ROCKERDAN]

Brent, are you breaking the belts on big trails(higher speeds) or corner to corner?

Where is offset at now? And have you recently checked it after each blow?

Remember stub can move on blow.

Hmmm.....I wish you had some Daltons just to test. I also snapped my Ultimax within 50 miles using STMs.

What helix you running?

Dan

 

[PowderFalcon]

Brent, are you breaking the belts on big trails(higher speeds) or corner to corner?

Where is offset at now? And have you recently checked it after each blow?

Remember stub can move on blow.

Hmmm.....I wish you had some Daltons just to test. I also snapped my Ultimax within 50 miles using STMs.

What helix you running?

Dan

Seems to be after a good long pull. Then 2 minutes later it goes.

Last belt blow it did change my offset by 1mm. I adjusted for that.

Blew ultimax in 350 mile and now 8dn in about the same mileage.

Making some adjustments in my weights as suggested by CM. See how that works.

37/35 helix

 

[ROCKERDAN]

Seems to be after a good long pull. Then 2 minutes later it goes.

Last belt blow it did change my offset by 1mm. I adjusted for that.

Blew ultimax in 350 mile and now 8dn in about the same mileage.

Making some adjustments in my weights as suggested by CM. See how that works.

37/35 helix

Ok so you run a lower helix too, that is same as me. I doubt you are slipping up top.

Yeah see what adjustments do for you on this STMs. The very reason I went back to Daltons, I just like the simplicity, so hopefully the gurus here can dial you in.

Dan

 

[PowderFalcon]

Ok so you run a lower helix too, that is same as me. I doubt you are slipping up top.

Yeah see what adjustments do for you on this STMs. The very reason I went back to Daltons, I just like the simplicity, so hopefully the gurus here can dial you in.

Dan

I haven’t ran it up top in fear of blowing another belt! Trying to get the clutches cool first before doing more top end passes!

 

[ROCKERDAN]

Brent do you have alot miles on the SRX yet? Just wondering.

Dan

 

[PowderFalcon]

Brent do you have alot miles on the SRX yet? Just wondering.

Dan

Just over 1500 miles.