What carbides do I need for tuner skis?

[Albanyco]

I bought this sled last year but the carbides are totally shot. What do I need to order for carbides for it? Do I need a set of 4 inch carbides and a set of 2 inch? Sled pushes in corners but I’m not surprised considering there is about nothing left.

 

[TPAY243]

I used the 6 inch carbide Woddys Ace Bar on the inside with the stock 4 inch carbide round bar on the outside. It work pretty good but when the trails warm up and get a little mushy they will push when running hard but when things are frozen up it will be on rails with no push or darting what so ever. I have messed around with ski's and found the Cat ski with the staggered carbide or snow trackers work the best. You will get a bunch of different opinions on this but that's what I found works the best with out buying aftermarket ski's.

 

[sab2022]

My question also...
OR should I give up on the turner ski's and invest in that other ski and the associated carbides for that other ski?

example: "Cat ski with the staggered carbide or snow trackers work the best" ....understand Yamaha is going with Stryke ski's this year?

 

[ClutchMaster]

Donate those tuner skies to the garbage man and get some C&A’s or Curve XS.....
Curves are easier to steer, C&A’s are Point and shoot, no push.

 

[TPAY243]

Stryke ski is basically a cat ski on the bottom it uses the same bolt pattern for the wear bars.

 

[Teamblue4]

Snowstuds carbides 6" and 8" been using this combination for over 30,000 miles.

 

[sab2022]

Would C&A, Curves ski's be impacted (helped/harmed) by Electric Power Steering (EPS) install summer 2021/2022??
Thanks

 

[ClutchMaster]

Can’t imagine it would affect anything. I’m sure it shouldn’t matter if you have PS

 

[Albanyco]

I’d love to pitch the tuner skis, but I’m going to be stuck with them for this season. So do I need to purchase two sets of different lengths, two sets of equal length or what? It’s confusing because the manufacturers list carbides by make and model and so I have no idea what carbides fit what.

 

[maim]

the tuners on my 16 lasted 4 rips across a meadow before i removed them and replaced them with mtx skis. i have heard a few guys liking bergstrom's set up for tuner skis.

 

[Teamblue4]

I’d love to pitch the tuner skis, but I’m going to be stuck with them for this season. So do I need to purchase two sets of different lengths, two sets of equal length or what? It’s confusing because the manufacturers list carbides by make and model and so I have no idea what carbides fit what.

2 sets, 1 set of each pair.

 

[Yamajon1]

I ran 6 inch on the inside and 4 inch on the outside when I had the tuner skis.

 

[snobill]

I ran 6 and 6 on my attak , still pushed bad unless on hard pack . I suffered through those skis a few years then went back to the stock single and was better . Then got mtx skis on my 12 apex , world of difference in turning and floating on deep snow.

 

[SqueezeER]

Don't waste your money. Just get new skis.

 

[ateick]

If you're going to keep them:

6" square carbide shaper bar inside Woody's Carbide Ace Runner - AY6-8500 -- round 4" carbide on outside Woody's Extender Trail III Flat-Top Carbide Runners - EYV3-8500