Search results

The shock dimensions are correct but you may have to trim the spring retainers as your vector doesn't use a coil over shock. When I had my 05 vector I sent a rear viper shock to Pioneer Performance and told Bruce the application. He valved it perfect and I trimmed the spring retainer for the...

06 mono skid that has been abused. Rear arm must have done a lot of bottoming. Slight cracks by the bolt holes where the reinforcing plates are in the center of the rails. Removed the bump stops and reinforcement plate and this is what I found. Question is are they useable. I've read that...

sounds like the TPS Sensor http://www.ty4stroke.com/viewtopic.php? ... highlight=

Learned that tip on this site. glad to share. I store mine with stabilized fuel, not topped up. Never tried draining them.

Take 5 minutes and try this first. Remove clutch side panel and clutch cover. On the frame for the foothold there is the vent line for the fuel tank encased in a flex spring. Remove the clamp and blow into it to pressurize the fuel system. Hold your thumb over it and crank the sled. I have...

triton 10' with a blizzard cap and my Vector Ltx fits fine. Only issue is the snow flap sometimes gets hung up when I open the cap. I just open it 6 inches and reach under and push the snow flap forward a few inches and open.

I've only ever done it with the rear transfer rod bolt out and never had a problem. Not sure if it would help.

Wix has a cross reference for the 5DM-13440-00-00 filter http://www.wixfilters.com/filterlookup/ ... mit=Search

I hear ya. My co-workers don't get it when I have a nice winter trail pic as my wallpaper in the middle of summer.

Is ty4stroke the default homepage for the browsers?? :Rockon:

I 2nd that. Use WD40 and rub with your fingers to dissolve the glue then wipe off. Make sure to prep well for new graphics.

The tunnel width should be the same but the mounting points are different. The 03 (proaction) has 3 bolts per side but the 07 (proactive CK) only has 2 bolts per side. You would have to get measurements and redrill for the proactive mount plates. Good luck, maybe someone else has done this and...

http://www.desertsleds.com

the 12V accessory circuit on my 08 is a 3.0 (three) Amp fuse.

I agree, 98% darting gone with shimmed 6" triple points

ski savers scrubbed top end and ate into fuel mileage big time for me. I now run without ski savers. Just the shims. Great carbides.

Anyone know how the snowtrackers are for loading and unloading on a trailer?? Looks like they would grab and put you over the bars...

The rear shock in the 05 Vector is a sealed hydraulic unit that is totally inadequate. The proactive is a decent skid but needs a better rear shock.

Available in US too. Shows on Port's site SNOW WHEEL KIT (SMA-8FT95-00-00) $67.16

What's the cost of the kit?