Flywheel Puller for Genesis 120 engine

[Jack_Shaft]

I have to change the one-way bearing out on the RS engine in a 2006 VK Pro. Is there a generic puller that can be used to do this? Crowfoot? I am reading that the threaded receiver holes are M8?

Any suggestions or guidance from experience?

 

[Srxspec]

3 bolt puller, I use this one

https://www.ebay.com/itm/2972510404...PmpvNl3TKS8mCesdZbKfF6P3okiok8kQaAhxhEALw_wcB

 

[Jack_Shaft]

Ok, so any crowfoot style puller *should* work as long as you have the right thread (M8?) puller bolts 3x

 

[Srxspec]

Yes, M8 x 1.25 x probably 75-80mm length