TPI questions

[fourload]

Looking to upgrade my new Winder's stock clutching. TPI rollers, glide washers, secondary spring and primary spring. Later after I tune it I will get the flyweights. What is the recommended twist for the orange secondary spring with the stock helix? What will be the engagement with the TPI Sidewinder primary spring?

 

[Dieselxtx]

You might as well order the whole kit it will save you money in the long run and the kit works very well stock to 285hp instead of piecing together the weights primary spring and glide washers separate. Set the secondary spring to 3-3. You will see gains with the weights even stock.

 

[shagman]

The orange primary spring won’t work with the stock weights as it’s different than the stock spring. Set the helix at 3-3.

 

[XP123]

The orange primary spring won’t work with the stock weights as it’s different than the stock spring. Set the helix at 3-3.

That I didn't know. You can however just change the orange secondary spring with the stock weights right?

 

[NOS-PRO]

That I didn't know. You can however just change the orange secondary spring with the stock weights right?

Yes

 

[silverram323]

The orange primary spring won’t work with the stock weights as it’s different than the stock spring. Set the helix at 3-3.

Huh, I just installed both orange springs and I talked to lonn on the phone and he didn't say anything about it not working with stock weights. He said that the oem spring wasn't consistent and there was coil bind, there spring is shorter to eliminate that. I also put in glide washers.




Sent from my iPad using Tapatalk Pro

 

[silverram323]

Pics won't load with ipad

Sent from my iPhone using Tapatalk Pro

 

[shagman]

Huh, I just installed both orange springs and I talked to lonn on the phone and he didn't say anything about it not working with stock weights. He said that the oem spring wasn't consistent and there was coil bind, there spring is shorter to eliminate that. I also put in glide washers.




Sent from my iPad using Tapatalk Pro

Your engagement will most likely be pretty low, but you might like it.

 

[silverram323]

Your engagement will most likely be pretty low, but you might like it.

I don't mind a low engagement especially when we're out west


Sent from my iPhone using Tapatalk Pro

 

[silverram323]

Your engagement will most likely be pretty low, but you might like it.

What is the stock engagement, i never paid attention.


Sent from my iPhone using Tapatalk Pro

 

[**sj**]

silveram...not sure because i have old eyes for close work...but do I see a flat spot on a roller?

 

[silverram323]

silveram...not sure because i have old eyes for close work...but do I see a flat spot on a roller?

No. They are cat rollers.


Sent from my iPhone using Tapatalk Pro

 

[**sj**]

 

[silverram323]

I gave them a full inspection and clean up when I installed the new springs and Glide washers.


Sent from my iPhone using Tapatalk Pro

 

[shagman]

What is the stock engagement, i never paid attention.


Sent from my iPhone using Tapatalk Pro

You got me. I haven’t been stock since the 300 mile mark early last year. Lol. But I know it will be lower with our spring and stock weights.